Set up your TorrX in minutes.

Charge it, turn it on, choose manual or auto mode, and start with a lubricated needle.

Charge first

• TorrX ships with a low battery charge. Charge it for at least 2 hours before your first full use.

Turn TorrX on

• Twist the cap clockwise.
• Push up to expose the needle.
• Twist counterclockwise to lock it in place.
• The TorrX is ON when the three-digit display lights up.
• Reverse those steps to close the cap and turn TorrX off.

Manual mode

• MANUAL MODE is the factory start-up mode.
• The display reads ‘00.0’ before the needle enters the ball.
• Hold TorrX so your thumb can reach the buttons, then insert the needle.
• The display will indicate the current ball pressure.
• Press ‘+’ to inflate or ‘–’ to deflate.

Auto mode

• Double-click the circular ‘A’ button.
• The Target Pressure flashes and the green ‘A’ light turns on.
• Use ‘+’ or ‘–’ to change the Target Pressure.
• Press ‘A’ to start. TorrX will add or release air until it reaches the target, then beep three times.

Switch modes

• Double-click the circular ‘A’ button to move between MANUAL MODE and AUTO MODE.
• The green ‘A’ light shows when AUTO MODE is active.
• Unless you change the default, TorrX returns to MANUAL MODE when it turns off.

Change default mode

• Put TorrX in AUTO MODE.
• Press and hold ‘+’ and the circular ‘A’ button together until TorrX beeps.
• Repeat the same step to return the default mode to MANUAL.

Battery lights

• The Battery Status light is above the ‘+’.
• The light is GREEN if the battery is fully charged.
• The light is BLINKING GREEN if the battery has a good operational charge.
• The light will begin BLINKING RED when the battery needs to be charged.
• The light will be SOLID RED when the battery is exhausted.

PSI or BAR

• The default unit is PSI.
• Press ‘+’ and ‘–’ together to switch to BAR.
• Press them together again to return to PSI.

Need specs, price, or warranty details?

See TorrX product details

More questions? Email support@torrx.com.